5 Comments

Add a Comment
  1. Of course, I think we were on the same path here. Thanks for confirming. 🙂

  2. The negative side of the battery snap is your ground reference. It’s “Ground”.

  3. So you don’t need to put the negative side of the battery snap anywhere? Just cover the exposed wire end, and its’ good to go?

    Thanks 🙂

  4. Hi, Stephen. I’m not sure I understand you correctly. There’s no -9v involved here. You basically connect a battery to the +9v and ground, your multimeter to the “DMM” points and a switch to the remaining points.
    Or did you mean to post this in relationto the charge pump circuit?

  5. Hi there, great site!

    I’m still a bit of a noob at this stuff. Can the -9V be attached to the ground line on the vero, or should it be going somewhere else?

    Cheers 🙂

Leave a Reply

Your email address will not be published. Required fields are marked *

Time limit is exhausted. Please reload CAPTCHA.

SabroTone © 2010-2016 Frontier Theme